What have you done to your Pajero today? - Page 53

Spikv · Sat Feb 21, 2015 5:10 pm

G3PajV6, Where did you get the vinyl from and what did it cost?

andrew.ashton · Mon Feb 23, 2015 10:26 am

Topped up fuel tank, engine oil & coolant and growled down to Swinburne and back over the weekend with a little 4x4 low range driving up a mountain at Swinburne.

G3PajV6 · Mon Feb 23, 2015 11:23 am

Spikv wrote:G3PajV6, Where did you get the vinyl from and what did it cost?

The Racers Edge , Bought the cheap stuff R30 a meter , I bought 10m. China import with name Catpiano. did the tailgate. The sheet I had was to small and I had to cut the vinyl. Will do the rest to the top and will have a join line inline with the back window where it stops at the moment. Not what I wanted but I am not going to redo this. I removed the bracket for the spare wheel and spray painted the bracket matt black did the same for the plastic holding the number plate. Looks ok. I will finish this and do the entire car with vinyl. Will do a panel a day.

Spikv · Tue Feb 24, 2015 10:17 pm

Are you not worried that the cheap stuff will start peeling sooner rather than later? Got a price from RMT for R90 for a 1m x 1.5m piece. R30 sounds better because ill have to practice a couple times I'm sure. Is the stuff you got just 1m wide?

G3PajV6 · Wed Feb 25, 2015 1:28 pm

I took 10m for R300 not sure what the width is they cut the length you want , yes they have another role that is wider that you can use for the tailgate and roof that is R150 per m. They cut the length you want.

I took the cheap R30 stuff and joined the two.

I don't think it will peel a co-worker had it on his new Ford ST for 2 years now without any problem. it depends on the application.

larry007 · Sun Mar 01, 2015 7:23 am

I tried my hand at pinstriping yesterday! After a complete respray an with all tge decals removed, she seemed a bit too much black and white. I must admit the wrap on sides is very appealing to prevent those nasty scrapes in the bush on a new paint job

andrew.ashton · Sun Mar 01, 2015 3:09 pm

@larry007,

Looking good!

pfgrobler · Sun Mar 22, 2015 10:30 pm

I wanted to replace my 2 bolt per side tow bar with a heavier duty 4 bolt per side one.

But found this

I was surprised how "loosely" the bumper is attached. and decided that I need a proper socket set.

Roy · Tue Mar 24, 2015 7:50 am

Had side "impact bars" fitted on my Pajero by Noise Boys in Kathu.

larry007 · Tue Mar 24, 2015 2:47 pm

Those bars look nice and mean. Do you have some plans to get them manufactured? And what are the costs on these?