Page 1 of 1

2.5 Tdi Turbo reconditioned & 3.5 V6 throttle body cleaned

Posted: Tue Jul 19, 2011 12:35 am
by nino62
Remember to clearly mark vacuum pipes in order
Remember to clearly mark vacuum pipes in order
IMG_1671.jpg (23.21 KiB) Viewed 600 times
Normally 5x bolts holding the housing in place (4x in front & 1x on side bracket)
Normally 5x bolts holding the housing in place (4x in front & 1x on side bracket)
IMG_1673.jpg (23.05 KiB) Viewed 600 times
What the throttle body should look like, after thorough clean-out (including rear inlet housing) & no play on butterfly shaft
What the throttle body should look like, after thorough clean-out (including rear inlet housing) & no play on butterfly shaft
IMG_1675.jpg (22.8 KiB) Viewed 600 times
IMG_1724.jpg
IMG_1724.jpg (22.95 KiB) Viewed 600 times
Regards

Achille

:D

Re: 2.5 Tdi Turbo reconditioned & 3.5 V6 throttle body clean

Posted: Wed Jul 20, 2011 11:03 am
by Blister
Achille ad I did both our Blisters onthe same day and I found it extremely "comforting" and fun.

I filled the tank (petrol + 2T oil) and after journey to Citrusdal and back recorded 11% improvement which equated to 6km/l. Still good but improvement :roll:

I am still confused why the ECU unit had to be opened because it was very clean inside :?