Hi All!

Looking for an engine for my Pajero, haven't had much luck finding a good one online so thought id try here.

Let me know.

Also if anyone...

Good day

Please help, I’m looking for the throttle angle sensor for 1996 Pajero 4m40 2.8 Diesel

Hi guys. We’re travelling along the Western Cape south coast and my Gen 3 Swb 3,2 Diesel has started doing an odd thing on start up in the mornings....

Hi all

My 2007 3.2 DiD has just reached 400,000 kms a few months ago. Still going well apart from one or two niggles that surfaced recently. (4m41,...

Back in March I was parked around 30 Km or so from home. When I started the engine, all seemed normal but pulling into traffic the Pajero was very...

O, time for the big guns...got any advice? 2001 Pajero 3.5 GDI 6G74

Liiving in TZ and driving north to Arusha. Filled up at the wrong station...

Hi everyone,

I have a 4M40 Pajero with the Zexel VE mechanical pump. I'm trying to locate a replacement overflow valve (fuel return pressure valve)...

Good Evening

4D56U 2.5 D high output motor 2014 pajero sport

i recently had the head replaced, if stretch bolts were used and torqued correctly....

We have the regular 70L tank and an aux tank above spare wheel (about 30L). Needle stays at FULL mark until aux tank is empty. I found that the range...

We have the regular 70L tank and an aux tank above spare wheel (about 30L). Needle stays at FULL mark until aux tank is empty. I found that the range...

I have a puzzling overheating issue with my 2015 Pajero Sport (2.5d, 4D56T engine with 250k km on the clock) that I'm hoping one of you gurus could...

Hi guys, I bought a 1999 Pajero 3500 V6 blister fender a month back, previous owner has had the engine blueprinted. I want to know where I can get...

Good day

I am beginning to question the reliability of the 4D56U high output motor.

i have recently done the head on mine, 6 months ago

now i have...

Hi guys, I bought a 1999 Pajero 3500 V6 blister fender a month back, previous owner has had the engine blueprinted. I want to know where I can get...

Hi guys, I bought a 1999 Pajero 3500 V6 blister fender a month back, previous owner has had the engine blueprinted. I want to know where I can get...

Good day

does anyone have some instructions for changing the fuel filter on a 2.5DiD Sport?

thanks
Mark

Good day

does anyone have some instructions for changing the fuel filter on a 2.5DiD Sport?

thanks
Mark

hi all
i have done quite a bit of reading and after owning the vehicle for 2 weeks I want to replace all oils.
I have seen that most say Caltex Delo...

Need help please!Engine light iluminates on hard excelleration on long road,goes to limp mode.Suspects dump valve is sticky.can one reach without...

On travelling about 35 Km in the morning to work no problem with my 2008 Gen 4 diesel 3.2. (± 270,000 km)
On sitting for 8 hours, on the way home,...

Looking for the following
ME203093 Guide
ME191470 Piston
GEN3 2006. 4M41 Engine

Used or New

I am in Bloemfontein

Hi,

I recently replaced my 6G74 rear cam o-ring Right side.

The Left side is not so easy. I cannot get a small 12mm socket in there to remove the...

Sorry for this post i know there is a lot of posts on this subject.

However the 2 questions I have :

1. What type (specification) of two stoke...

Some advice please: I have a Pajero 3.8 MIVEC, 2008 model, petrol, swb. The engine fan is always on, even on engine start up, and I assume it stays...

I have a 2005 3.2 Did LWB with 240 000km on the clock. I'm considering to put in a Unichip with the additional option for 5 user defined mappings...