Page 1 of 1

Ferrodo brake pads for Gen 3

Posted: Thu Jun 19, 2014 11:35 am
by Pecheck
Good Morning,
Does any one know if these are the correct pads for my 2004 3.8 lwb. I had them shipped to me and don't want to break the seal if they are incorrect.

Your help is appreciated.

Re: Ferrodo brake pads for Gen 3

Posted: Thu Jun 19, 2014 9:22 pm
by Lock
The Ferrodo brake pads was listed wrong. This was about 2 years ago. The pads then supplied did not fit my 2002 and only the Dealer had the right pads. I would check before opening! Not sure if all the series 3 used the same pads? The dealer had to get the Vin number of the car before he could get the right pads

Re: Ferrodo brake pads for Gen 3

Posted: Mon Jun 23, 2014 10:01 am
by Dirty Boy
As a matter of interest, how much are a set of pads from a Dealer ?

I recently changed the front pads only on my SWAMBO's Kia Soul (cheapish small, light car, or so you would think)
I went straight to the Dealer because I didnt want to have fitment problems or drive from Midas to AutoZone looking for the right ones.
R1600 :shock: Wasnt sure if I should put them on the car or in the safe.

Re: Ferrodo brake pads for Gen 3

Posted: Mon Jun 23, 2014 1:23 pm
by Pecheck
My dad work for federal mogul which own ferodo, so he called in a favour, but they only worked off a list when ordering, that's why I asked.

Have to get a part from Mitsubishi Friday, will take the brakes with, they might know.

Re: Ferrodo brake pads for Gen 3

Posted: Mon Jun 23, 2014 1:56 pm
by 4ePajero
Take out one pad from the Pajero and check it against the image on the box (they are usually actual size!).

PS Have you tried Powerbrake in Pretoria?

Re: Ferrodo brake pads for Gen 3

Posted: Mon Jun 30, 2014 12:38 pm
by Pecheck
Want to the dealers to pick up my vacuum solenoid. They said both are front brakes, the Larger box is apparently for a DK model.
Anyone want to trade me for rear brakes?