Page 1 of 2
Patrol springs in Gen2
Posted: Tue Oct 13, 2015 4:18 pm
by SimonB
Yes I've been quiet
I've FINALLY had the patrol springs fitted into my Paj, but I had NO idea of the lift it would provide.
So now it looks all out of kilter.
Can the torsion bar be tweaked far enough to level it? Or should something else be done?
Sent from my iPhone using Tapatalk
Re: Patrol springs in Gen2
Posted: Tue Oct 13, 2015 4:52 pm
by SimonB
The rear wheel arches are now a full 14cm higher than the front
Sent from my iPhone using Tapatalk
Re: Patrol springs in Gen2
Posted: Wed Oct 14, 2015 7:07 am
by Nick Gibson
Tweak the torsion bars and the ball joint flip - as per the colt suspension?
Re: Patrol springs in Gen2
Posted: Wed Oct 14, 2015 8:43 am
by Roy
Hi
Explain the ball joint flip and what to do.
Re: Patrol springs in Gen2
Posted: Wed Oct 14, 2015 9:57 am
by Nick Gibson
Roy wrote:Hi
Explain the ball joint flip and what to do.
Google is your friend...
See here:
https://www.4x4community.co.za/forum/sh ... p?t=114606
Re: Patrol springs in Gen2
Posted: Wed Oct 14, 2015 11:44 am
by Roy
Thank you
Re: Patrol springs in Gen2
Posted: Wed Oct 14, 2015 11:53 am
by Roelf_le_Roux
Simon who???
Re: Patrol springs in Gen2
Posted: Wed Oct 14, 2015 1:32 pm
by Nick Gibson
Roelf_le_Roux wrote:Simon who???
Re: Patrol springs in Gen2
Posted: Wed Oct 14, 2015 5:50 pm
by SimonB
Sent from my iPhone using Tapatalk
Re: Patrol springs in Gen2
Posted: Wed Oct 14, 2015 7:31 pm
by Roelf_le_Roux
Oops.
That is rather a hectic lift.
