Page 1 of 1
Pajero Gen 4 Window Switch Trim Covers
Posted: Thu Feb 02, 2017 7:28 am
by Ian Visser
I will appreciate it if anybody can advise how to remove the power window switch trim covers (those silver covers surrounding the window switches) on a Pajero Gen 4. Mine shows a bit of fading and I would like to remove it to respray it.
Re: Pajero Gen 4 Window Switch Trim Covers
Posted: Thu Feb 02, 2017 12:06 pm
by KurtG
Simple. Take a plastic egg lifter or similar and wedge it in the gap and pop it up, extremely simple.
Sent from my iPhone using Tapatalk
Re: Pajero Gen 4 Window Switch Trim Covers
Posted: Thu Feb 02, 2017 10:22 pm
by Ian Visser
It is a very tight fit. What keeps it in place?
Re: Pajero Gen 4 Window Switch Trim Covers
Posted: Fri Feb 03, 2017 6:24 am
by KurtG
Ian Visser wrote:It is a very tight fit. What keeps it in place?
Just some small clips that require force to unclip but they don't break easily. When wedging the egg lifter just keep putting more and more pressure, eventually it pops open
Sent from my iPhone using Tapatalk
Re: Pajero Gen 4 Window Switch Trim Covers
Posted: Fri Feb 10, 2017 3:01 pm
by Ian Visser
Thank you, your advice was spot on.