Pajero Owners Club of South Africa

I can send you the diagrams of the vacuum lines to your email if you want.

BenjieMan wrote:I can send you the diagrams of the vacuum lines to your email if you want.

thanks mate that would be great
i have sent you a PM

cheers James

have you had a read through this thread of mine?

https://www.pajeroclub.co.za/forum/viewtopic.php?t=3035

OK , i have changed the sensors, it did help a little
it now holds the revs to what you rev it to e.g change gear at 2200rpm and it stays at 2200rpm till you let the clutch out for the next gear

i will say when i swapped the sensors it was easier to remove the water housing on the head & the temp sensor under that to give clear access to the bolt on the top sensor
i noticed quite a bit of build up on the sensor in the head, when i cleaned it off it was back to shiny brass, also did the same to the one in the throttle housing

so i am still stumped

could there be an issue with the temp sensors or the vacuum solenoids ???????????

there is some oil residue in the throttle body

and i have blanked off the egr

would the car need to do the idle re-learn after i change those sensors?