Or you can use a thread insert like Heli Coil / Time-Sert.andrew.ashton wrote:What about using a thread-forming liquid? Permatex and Loctite, amongst others, make this stuff. If you search those product names + "thread forming liquid" on Google / YouTube you will find available products and How To videos.
!! Luckily I founds all the lengths and specs on the Service manual.
Didn't Marius once mention using a Golf idler pulley? - can't remember if it was for the same application though.Nick Gibson wrote: On another note, I am looking for the plastic idler pulley for the fan belt, want to avoid the stealers if I can - they charge R589.82 each, but steep I think... It is a 24mm wide by 7 rib belt by 74mm in diameter?? Suggestions? I found the steel one at masterparts for R 189.00, no plastic one thus far at them or Alert engine parts.
Okay, so it pays to phone around just to make sure. Masterparts here near me(Stikland) does not have the grooved poly 'V' belt pulley for the 6G74 motor and said the franchise does not stock them at all, but Kenilworth branch does have in stock ... go figure!!andrew.ashton wrote: Didn't Marius once mention using a Golf idler pulley? - can't remember if it was for the same application though.
4880027.pdf
Looks good! Are you installing a long range tank, or is this only for a second spare?Bostokkelos wrote:Mounted a rear spare wheel carrier
)
)
Looks good. Only needs a Pajero Club sparewheel cover to finish it off nicely!Bostokkelos wrote:Mounted a rear spare wheel carrier
How much does it cost if you are a test subject?Bateleur wrote:Fitted what I hope is the last of the Dev Cycle of the Stofpad 4x4 Gen 4 Rocksliders. They are superbly built and unbelievable strong! Will be testing them in Lesotho/Drakensberg this coming week!
WP_20130628_003.jpg
P.S. I think he needs one more LWB test vehicle!