Hi All
My 2007 paj has n standard steel bash plate with the plastic bash plate behind that to protect the lower half of engine (sump and 4h actuator) The plastic section has broken and I would like to have it manufactured from steel. Does anyone perhaps know who will be able to assist?
Apparently the V6 cross member is a different length to the diesel’s. Most complete aftermarket bash plates are for the diesels.
Cheers
Have a look here.
https://www.trailandbeyond.co.za/bash_plate.html Extremely well made, it will be the only thing left after the zombie apocalypse.
Laser cut with the Pajero name and the Diamonds
You do need someone to help you install, I did it on my own and suffered from Trigger Finger, it does exist, look it up. Came from trying to hold the bash plate with my fingers spread out and my right thumb taking the load. So be warned.
I had the same rubbish from the factory, I think it was made from discarded food cans and the like, totally inadequate.
https://www.trailandbeyond.co.za/bash_plate.html Extremely well made, it will be the only thing left after the zombie apocalypse.
Laser cut with the Pajero name and the Diamonds
You do need someone to help you install, I did it on my own and suffered from Trigger Finger, it does exist, look it up. Came from trying to hold the bash plate with my fingers spread out and my right thumb taking the load. So be warned.
I had the same rubbish from the factory, I think it was made from discarded food cans and the like, totally inadequate.