Having to panelbeat my excaliburs after each offoad trip I decided to build me some sliders.
The tubes are 50 mm x 5mm and the flatbar I used was 50 x 8 mm. And I used 10mm
high tenstile bolts to fatsten them.
They are strong enough to jack on and I putt recovery points on them aswell.
Here's the pics
Attachments:
- The pipe with the chassis bracket
- Slider test fit
- Recovery point planning
- Primed
- Finished
- Finished and cleaned
Thanx JohnG
Yip I painted them myself,I used RB10 for a primer-its a water based primer. And for the top coat I used enamel-recommended by the local paint shop. But I reckon if you realy want it to be strong 2k would be the way to go.
Yip I painted them myself,I used RB10 for a primer-its a water based primer. And for the top coat I used enamel-recommended by the local paint shop. But I reckon if you realy want it to be strong 2k would be the way to go.
Affiliate Member
Good looking addition congrats.
2K be a bit brittle for this application too much stones and chipping but Hamerite smooth is not as brittle and as bonus it has a potent rust inhibitor.
2K be a bit brittle for this application too much stones and chipping but Hamerite smooth is not as brittle and as bonus it has a potent rust inhibitor.
Henk Bannink
Some people are wise, some people are otherwise
Some people are wise, some people are otherwise